ATTiny88 board upload issue
-
Hello!
I'm trying to upload code to the board listed in subj.
Here is my log of Arduino IDE:
Running Digispark Uploader...
Plug in device now... (will timeout in 60 seconds)Please plug in the device ...
Press CTRL+C to terminate the program.
Device is found!
connecting: 16% complete
connecting: 22% complete
connecting: 28% complete
connecting: 33% complete
Device has firmware version 2.2
Device signature: 0x1e9311
Available space for user applications: 6650 bytes
Suggested sleep time between sending pages: 7ms
Whole page count: 208 page size: 32
Erase function sleep duration: 1456ms
parsing: 50% complete
Erasing the memory ...
erasing: 55% complete
erasing: 60% complete
erasing: 65% complete
Starting to upload ...
writing: 70% complete
writing: 75% complete
writing: 80% complete
Starting the user app ...
running: 100% completeMicronucleus done. Thank you!
Everything seems ok, but the LED does not blink with the frequency I set. It just blink as it was before I did anything.
Please help!-)
-
Hi there. Did you ever get a resonse to this?. I have the same issue all seem to go ok, but the "blink" test just doesn't seem to work and the red light remains blinking at the same (erratic) rate.
Regards
UKDEL
-
No there is nothing-) I wrote to aliexpress seller. They offered to refund an order. They don't know how to deal with it. They just sell this equipment.
-
Did you use the pin 0? Notice that the built-in LED is on a different pin (0) than on usual Arduino Nano/Uno, where it is on pin 13.