Use espressif AT COMMAND for esp32

[MH-ET LIVE]

When i used the AT command first time,i found it easy to been plagued with some problems. So i make a simple guide,hope it is helpful for everyone.
Guide is in Windows.For your reference only.
All the things following are based on espressif`s ESP32 AT firmware.Download here:http://espressif.com/en/support/download/at
More details are in documentation:esp32_at_instruction_set_and_examples_en.pdf
Esp32 download tools:http://espressif.com/en/support/download/other-tools

First erase the flash:
This way is necessary because it can avoid errors.
Download a bin file:https://github.com/MHEtLive/ESP32-MINI-KIT/tree/master/AT/erase_flash_bins
Here we can call this bin file as "erase-file".It can be used for erase the flash when being downloaded to esp32.
Use esp-download-tool to deal with this "erase-file" as the fllowing guide picture.

Start and done!

Then Download ESP32 AT firmware:
Use esp-download-tool to deal with the "ESP32 AT firmware" as the fllowing guide picture after erasing flash.Make sure the address and config is correct.
Espressif`s download.config file show"--flash_mode dio --flash_freq 40m --flash_size detect //0x1000 bootloader/bootloader.bin //0xf000 phy_init_data.bin// 0x100000 esp-at.bin// 0x8000 partitions_at.bin".

Start and done!

Test AT-Command.
***notice:***When testing, serial port sending and receiving command with ESP32`s UART2 , not UART0 which used for downloading firmware, so obviously can't use the USB port on dev-board for the AT command, you should use an external serial port tool.Pin connections are as follows:

Use sscom or minicom to see the imformation during test.After connecting,open com and RST the esp32, you can see "ready" after a while.

and AT+RST

AT+GMR

Now,you can see you have been into AT-Command Mode.Detailed AT development process and commands are shown in PDF and the espressif`s website.Enjoy!