@Ghibli_69 Ignore "DPinst64.exe fails to install Digistump LLC (usbser)" just proceed to installing board info on Arduino IDE as described above.

@q12 Keep the device plugin and press the reset button to disconnect and reconnect it back when asked to plug the device.

Hi everyone, I got this MH-Tiny up and running with nRF24l01. It works well and the price to performance is amazing. I got it working with Arduino IDE. Tips: Just treat it as a regular Arduino board and you don't have to unplug the device, just press the reset button, and the board will disconnect and reconnect back.

Everything works fine

Re: MH-ET LIVE Tiny88(16.0Mhz)

I got the board setup and uploaded a few sketches successfully. However, I could not get the board to “read any inputs “ push button and potentiometer doesn’t seem to work. I had tested the sketch with Pi Pico, ESP32, and Arduino Uno with button and pot but it doesn’t seem to work on the Tiny88! Most of the videos or all videos on YouTube show only blink sketch nothing in-depth! If anyone can figure this out, please share the sketch or instructions, thanks

@Ghibli_69 Ignore "DPinst64.exe fails to install Digistump LLC (usbser)" just proceed to installing board info on Arduino IDE as described above.